1

Lifting Lug Verification

Strength check for plate lifting lugs (pad eyes): net-section tension, shear tear-out, pin bearing, base section and weld — with pass / fail utilization and a printable calculation record.

Verification 5 checks Allowable stress method
1

Load

Angled pulls bend the lug base — kept in-plane here; avoid side pulls on plate lugs
2

Lug geometry

Slightly smaller than the hole
3

Material & weld

Double fillet, both faces, full base width assumed

The five checks

Design load P = working load × dynamic factor. All checks use the allowable stress method with your material [σ]:

1  Net-section tension: σ = P·cosφ / ((2R − d₀)·t) ≤ [σ]
2  Shear tear-out (2 planes): τ = P / (2·(R − d₀/2)·t) ≤ 0.6[σ]
3  Pin bearing: σbr = P / (dp·t) ≤ 1.4[σ]
4  Base section: σ = P·cosφ/(B·t) + 6·P·sinφ·Hc/(t·B²) ≤ [σ]
5  Base weld (double fillet): τw = P / (2×0.7·hf·B) ≤ [τw]
φ = in-plane load angle from vertical. Bearing and weld allowables follow common steel-structure practice (GB 50017 style design values).

Most lug failures trace to two mistakes: hole too close to the edge (check 2 fails first) and welds sized by eye (check 5). If any check exceeds 100%, increase thickness, edge distance or weld leg — the utilization bars show which fix pays off fastest.

This tool covers in-plane loading on a single plate lug. Side pulls, cheek plates, tapered lugs and fatigue loading need a full engineering check.

Indicative verification per allowable-stress practice. For certified lifting points, request a stamped calculation from our engineering team. © Kinocranes.

Leave Message

Kinocranes is a professional crane manufacturer. We integrate crane research and development, manufacturing, sales, installation and service.

Please feel free to contact us!

TO TOP

+8619037303917

[email protected]

0086-373-5968887